We were instructed to make a maze using a software and then we would use the cnc router to cut it out. I went to tinkercad as an alternate for inventor, this is where I created my maze. I created a large box and made that the base of my maze. I then created individual cut outs which would allow the marble to go through the maze.
Above is a screenshot of me putting together the cut outs on the base.
Below is the final maze.
I wasn't able to get the other requirements because we aren't at school.
From this project I learned more about how to use Tinkercad, I'm also still learning how to adapt because we don't have all the resources that we need. It's been hard since we don't have access to the actual machines like we would at school.